Chat with Agent 206

Fence Staining in Western Washington: What Lasts and What Doesn't

A fence takes more weather than your siding and gets a fraction of the attention. Here's how often to stain one in the Puget Sound climate, what it costs, and why the bottom six inches fail first.

A fence is the hardest-working wood on most properties, and it gets the least attention. It has no roof over it, no overhang, no shade from the house. Both faces are exposed. The bottom sits in splash from every rain, and in a Western Washington winter that is most days.

Then people wait until it is grey and furry before they think about it, which is years past the point where staining would have been cheap.

Why Fences Fail Faster Than Decks

A deck takes standing water, which is worse in one specific way. But a fence takes everything else.

Both sides, all day. The west face takes afternoon UV, the east face takes morning damp, and neither ever fully dries in winter. On a deck you finish one surface. On a fence you finish two, which is most of why fence work costs what it does.

The ground line is the enemy. Rain hits the soil and splashes back onto the bottom four to six inches of every picket and post. That strip stays wet long after the rest has dried, and it is where rot starts on nearly every fence we are called to look at. It is also the part homeowners never inspect, because you have to crouch.

End grain everywhere. Every picket has a cut top and a cut bottom. End grain absorbs moisture many times faster than the face of a board. A fence with 100 pickets has 200 end-grain surfaces, and most factory-built panels arrive with none of them sealed.

Nothing sheds water off the top. A dog-ear or flat-top picket holds water on its cut end. That is why tops go black and soft first on an unfinished fence.

How Often to Restain

In this climate, a fence wants attention every two to three years. Decks run a similar cycle, siding runs eight to ten.

The gap surprises people. The reason is that paint on siding is a film sitting on a vertical surface under an eave, shedding water within seconds. A penetrating fence stain is a finish inside the wood with nothing protecting it, on boards that stay damp.

The test is water. Flick some onto a picket halfway up. If it beads, the finish is working. If it soaks in and darkens the board, the finish is gone regardless of how the fence looks from the patio. Colour lasts longer than protection, which is exactly why people wait too long.

Shade changes the number. A fence under cedars in Woodinville or along a greenbelt in Issaquah grows moss and needs cleaning more often than one in open sun in Marysville. A north-facing run can be visibly mossier than the south-facing run on the same property.

What a Professional Fence Stain Involves

Cleaning first, at low pressure. Fence boards are typically five-eighths to three-quarters of an inch. A pressure washer held close enough to strip grey will also tear the soft spring wood out from between the grain lines, leaving a furry surface that drinks stain unevenly and looks worse after finishing than before. We wash at low pressure with a cleaner and dwell time, and let the chemistry do the work.

Then drying. Minimum 48 hours. Thin boards dry faster than decking, but “dry to the touch” is not dry. Stain applied over trapped moisture lifts within a season.

Repairs before finish, not after. Split pickets, popped nails, posts that move when you push them. Finishing a fence and then replacing boards leaves you with new bare wood against aged stain, and no reasonable way to blend it.

Spray and back-brush. Spraying alone lays stain on the surface. Back-brushing works it into the grain, which is the entire point of a penetrating finish. On a long fence the spray is what makes the job affordable, and the brush is what makes it last.

Both sides and the tops. A fence finished on one side only is half protected and will cup toward the unfinished face as it takes on moisture unevenly. If the fence is shared with a neighbour, that conversation is worth having before the crew arrives.

What It Costs

Fence work is priced by linear foot and by height, since both faces get finished.

ScopeTypical range
Standard 6 ft cedar fence, per linear foot$7 – $14
Typical residential run, 100–150 linear ft$900 – $1,900
Add: heavy cleaning on a neglected fence$1 – $3 per ft
Add: picket or post replacementQuoted per board

What moves the number: how grey and mossy the fence is, since cleaning is the labour-heavy step. Access, because a fence with planting beds tight against it takes masking and hand work. And whether both sides are reachable, since a run against a neighbour’s hedge is slow going.

A fence in good condition restained on cycle is near the bottom of that range. One that has been ignored for eight years is at the top, and sometimes the honest answer is that replacement is the better spend.

When Staining Is the Wrong Answer

We turn down fence work. Posts soft at the ground line mean the fence is coming down within a couple of seasons, and stain does not consolidate rotted wood. Widespread cupping and splitting across most pickets is the same story. If more than a quarter of the boards need replacing, you are rebuilding a fence one board at a time at a worse price than rebuilding it properly.

The useful version of that conversation happens before anyone quotes a finish.

Timing in This Climate

Fence and deck work runs May through October here, same as exterior painting. We need the wood genuinely dry and surface temperatures above 50°F with a dry window after application.

September is underrated. The wood has had all summer to dry out, the heat that makes stain flash off too fast has passed, and schedules have opened up after the August rush. Spring is popular but the wood is often still carrying winter moisture, which pushes the start date later than people expect.

If your fence and deck both need doing, do them together. It is one mobilisation, one crew, one set of masking, and the finishes can be matched or deliberately contrasted while someone is standing there to look at both.

Our deck staining guide covers the deck side of that in detail, including stain chemistry and the brightening step.

Get a free fence and deck estimate or call (206) 930-8885. We serve Lynnwood, Bothell, Woodinville, Snohomish, Issaquah and 23 cities across Snohomish and King County.